Our polyester light filters are 2'x4'  and fit most classroom and office flourescent lights 

Each filter has eight or ten magnets on the outer edge of the filter you use to attach them to the outside of your fluorescent light fixture frame.

Unfortunately, you cannot trim the light filters to a custom size.

Yes, you can either move the light filters to a new spot or fold and pack them away for later use.

Our polyester light filters should NOT be put into your washing machine due to the magnets sewn into each cover. For daily maintenance, use a dry cloth to wipe off dust, while a wet cloth can be used for dirty areas.

If you notice creases in your filters, you can use an iron on either LOW or MEDIUM heat. You can also steam them to remove creases, but we do not advise putting them in a dryer.

Yes, these polyester light filters meet CPAI-84: 1995 Section 3, clause 3.2 regulations and each pack includes a fire safety certificate. Download a copy of the fire safety certificate here.

Each PVC film insert filter fits a standard 2'x4' fluorescent light fixture. The actual size of each filter is 22 1/2" x 46 5/8".

Simply open a fluorescent light frame and lay the filter flat (design side down) and close the light frame.

Yes, by using either a sharp pair of scissors or a boxcutter, these light filters can be trimmed to fit a smaller light fixture.

Yes! You can easily remove the light filters and place them in a new light fixture or roll them up and put them away for easy storage.

Use a micro fiber cloth to remove any dust.

Yes, these PVC film insert light filters meet FHSA 16 CFR 1500.44 regulations and each pack includes a fire safety certificate. Download a copy of the fire safety certificate here.